Know Your RoofUnderlayment & Roof Deck

Ice and Water Barrier: Where It Goes and Why

Last updated

Quick answer

Ice and water barrier is a peel-and-stick waterproof membrane that goes on the roof deck under the shingles. It seals around nails, so water backed up by an ice dam or driven by wind can't get through. It goes along the eaves, in valleys and around chimneys, skylights and pipes.

In this guide

How it's different from underlayment

Standard underlayment, synthetic or felt, sheds water running down the roof, but it isn't sealed at the nails. Ice and water barrier sticks to the deck and seals around each nail, so it can hold back water that sits on the roof. Many people call it ice and water shield, after one brand's name.

Where it goes

  1. Eaves: from the roof edge up the slope. Where code requires it, it reaches at least 24 inches inside the exterior wall line.
  2. Valleys: a liner down the center, where both slopes drain.
  3. Around chimneys, skylights, walls and pipes, where flashing meets the roof.
  4. Low-slope sections: between 2:12 and 4:12, Owens Corning allows it across the whole roof in place of a double layer of underlayment, and Ohio's code accepts self-adhered underlayment as an alternative.

What Ohio's code says

Where there's a history of ice forming along the eaves, as designated by local officials, Ohio's residential code requires an ice barrier on shingle roofs. It runs from the lowest edge of the roof to at least 24 inches inside the exterior wall line, measured along the slope. On roofs of 8:12 or steeper, it must also reach at least 36 inches up the slope from the edge. Code allows two layers of underlayment cemented together instead. Owens Corning's shingle instructions call for it on the eaves wherever roofs have a history of ice and water backup. Your local building department sets whether the code rule applies.

Does it stop ice dams?

No. It protects the roof when an ice dam forms, but the dam comes from heat escaping into the attic. The lasting fix is air sealing, insulation and ventilation.

Rooftop Relief inspects and repairs leaks at the eaves, valleys and roof openings for homes in Cincinnati, Loveland and across Greater Cincinnati.

Looking for another word? See the roofing terms glossary, A to Z.

FAQ

Ice and Water Barrier: common questions

How far up the roof does ice and water barrier go?

Where code requires it, at least 24 inches past the inside of the exterior wall, measured along the slope. On roofs of 8:12 or steeper, at least 36 inches from the edge as well.

Does the whole roof need ice and water barrier?

Usually not. It goes where water is most likely to back up or get in: the eaves, the valleys and around openings. Some shingle makers allow it across the whole roof on low slopes.

Is ice and water shield the same as ice and water barrier?

Yes. Ice and water shield is one brand's name that has become a common term for any self-adhered ice and water membrane. Roofers also call it leak barrier.

Still have a question?

Call and talk it through with our team. No pressure, no obligation.

  • Underlayment & Roof Deck

    Underlayment

    Underlayment is the water-resistant layer between the deck and the shingles. It's the backup if water gets past the shingles. Most roofs use synthetic or felt underlayment across the deck, with self-adhered membrane at the eaves, valleys and around penetrations, where leaks are most likely to start.

  • Roof Damage & Leaks

    Ice Dam

    An ice dam is a ridge of ice at the cold roof edge. Winter freeze and thaw lets snowmelt refreeze at the overhang, and the ice pushes meltwater up under the shingles. The cause is usually heat escaping into the attic, so the lasting fix is in the attic, not on the roof.

  • Flashing & Roof Edge

    Eave

    The eave is the lower edge of a roof, where it overhangs the exterior wall. It's where your gutters hang. Fascia, soffit and drip edge all meet there, and because water and ice collect at the eave, it's a common spot for leaks and rot.

  • Flashing & Roof Edge

    Valley Flashing

    A roof valley is the inside angle where two roof slopes meet. A lot of the roof's runoff ends up there, so it's lined with valley flashing, which is metal or waterproof membrane under the shingles. A failed valley is one of the more common sources of leaks.

  • Attic Ventilation

    Ventilation, Insulation and Air Sealing

    Attic ventilation, insulation and air sealing do three different jobs. Air sealing stops warm, moist air from leaking up out of the house. Insulation slows heat moving through the attic floor. Ventilation carries off the heat and moisture that still reach the attic. They work together, and none of them replaces the others.

Need a hand with this?

Inspections are free, and we respond within 2 hours, 24/7.

Free inspection

Ready to protect your home?

Get your free inspection today. Calls are answered 24/7, and we serve the greater Cincinnati area!

Step 1 of 6

What do you need help with?

  • Free roof inspections
  • Fully Licensed & Insured
  • Owens Corning Preferred Contractor
  • 760+ satisfied customers

Prefer to talk? Call (513) 560-1181

Call Now